In most cases, especially on NP, the oxides are to be removed using min. 110µm aluminus oxide.
(Refer to manufacturers manual!)
A clean and grease-free surface must be present.
Low
|
|
Process alloys according to manufaturers instructions. Avoid sharp edges. Unless specified otherwise, the alloy should be sandblasted with min. 110µm AL202 at 2 Bar. (35 psi) |
|
|
In most cases, especially on NP, the oxides are to be removed using min. 110µm aluminus oxide. (Refer to manufacturers manual!) A clean and grease-free surface must be present.
|
|
|
A uniform oxide layer is desired.
|